• sunbet(中国)

    Mitochondrial isolation protocol

    Elias Adriaenssens

    Published: 2023-09-23 DOI: 10.17504/protocols.io.kqdg3x4zzg25/v1
    AI 解读
    浏览 1618

    Abstract

    This protocol describes how to isolate crude mitochondrial fractions from HeLa cells.

    Attachments

    752-1920.pdf

    Steps

    Mitochondrial isolation

    1.

    Seed HeLa cells in 15 cm dishes and grow until confluence. Treat the cells with DMSO or the mitophagy-inducing cocktail Oligomycin/Antimycin A (O/A) if needed.

    2.

    Collect HeLa cells by trypsinization and resuspension in DMEM medium. Centrifuge the cells at 300x g,4°C.

    2.1.

    Resuspend the cell pellet in 1mL of ice-cold PBS (1x) and spin again for 300x g,4°C.

    3.

    Remove the PBS and resuspend the cell pellet in 1mL mitochondrial isolation buffer, which was cooled to 4°C.

    Note
    Note that the mitochondrial isolation buffer is prepared fresh on the day itself.

    4.

    To lyse cells without damaging the mitochondria, pipet the 1mL cell suspension up and down (15-20x) with a 26.5G needle.

    Note
    This should lyse the plasma membrane but leave organelles intact.

    5.

    Spin the suspension down at 600x g,4°C.

    5.1.

    Keep the supernatant and centrifugation 600x g,4°C.

    Note
    The mitochondria are located in the supernatant at this speed, the pellet contains intact cells, cell nuclei, and other large cell debris.

    6.

    After two spins at 600x g,0h 0m 0s, subject the supernatant to 7000x g,4°C.

    6.1.

    The pellet contains the mitochondria, so remove the supernatant and resuspend the pellet in 1mL mitochondrial isolation buffer.

    6.2.

    Then, centrifugation 7000x g,4°C.

    Note
    The supernatant from the first spin at 7000x g,undefine can be stored as a cytosolic fraction.

    7.

    After two spins at 7000x g,0h 0m 0s, subject the resuspended pellet to 10000x g,4°C.

    7.1.

    The pellet contains the mitochondria, so remove the supernatant and resuspend the pellet in 1mL mitochondrial isolation buffer.

    7.2.

    Then, centrifugation 10000x g,4°C.

    8.

    After two spins at 10000x g,0h 0m 0s, the pellet can be resuspended in RIPA lysis buffer or used for further procedures such as mitochondrial import assays, proteinase K protection assays, etc.

    推荐阅读

    Nature Protocols
    Protocols IO
    Current Protocols
    扫码咨询